MSDS

 


MAGIC MSDS

July 1, 2011

SECTION I -IDENTIFICATION

PRODUCT NAME: MAGIC

MANUFACURER: Annford Inc
Schreiber Industrial Park
New Kensington, PA 15068
telephone: 800-866-7627
24-hour telephone: 800-866-7627

PRODUCT TYPE: ................................. Alkaline liquid cleaning compound


SECTION II – HAZARDOUS INGREDIENTS

HAZARDOUS INGREDIENT C.A.S. NUMBER PEL
Sodium Hydroxide 1310-73-2 2 mg/m3 ceiling
Cocoamphodipropionate 68604-71-7 No limits established
Sodium Gluconate 527-07-1 No limits established

SECTION III – PHYSICAL DATA

APPEARANCE: Purple transparent liquid. No significant odor.
VAPOR PRESSURE :N/A
VAPOR DENSITY (AIR=1): Greater than 1.
SPECIFIC GRAVITY:1.1
pH:14.0
BOILING POINT: 210 degrees F.
SOLUBILITY IN WATER: Completely soluble.


SECTION IV – FIRE AND EXPLOSION DATA

FLASHPOINT: ...................................... This product is non-flammable.
EXTINGUISHING MEDIA: .................... This product is non-flammable. Use
extinguishing media suitable for materials already burning.
SPECIAL FIRE FIGHTING PROCEDURES:........................Firefighters working
in areas where this product is present should be equipped with an approved, fully
enclosed SCBA.
UNUSUAL FIRE AND EXPLOSION HAZARDS:......................... None known.



SECTION V – REACTIVITY DATA

STABILITY:........................................... Stable under normal conditions.
HAZARDOUS POLYMERIZATION: ...... This product not known to polymerize.
INCOMPATIBILITY: .............................. Do not mix with acids or other
detergents.
HAZARDOUS BYPRODUCTS .............. Carbon monoxide, carbon dioxide.


SECTION VI – HEALTH DATA

ROUTE(S) OF ENTRY: ......................... Inhalation, skin absorption, or ingestion.
LISTED CARCINOGEN: ....................... Not listed by IARC, NTP or OSHA.
MEDICAL CONDITION AGGRAVATED: May aggravate pre-existing dermatitis.
INHALATION: ....................................... Not likely to be inhaled in hazardous
amounts. Avoid exposure to mists or vapors. Maintain adequate ventilation in the
work area.
INGESTION: ......................................... This material can cause burns and
serious damage to any internal and external body parts.
EYES: ................................................... Undiluted product will cause burns or
eye irritation, or possibly blindness.
SKIN (DERMAL): .................................. This product may cause burns or
irritation if not immediately removed from the skin.


SECTION VII – FIRST AID

BREATHING (INHALATION):................ If victim shows signs of discomfort or
irritation, remove to fresh air. If symptoms persist, get immediate medical
attention.
SWALLOWING (INGESTION): ............. DO NOT INDUCE VOMITING! Drink a
large quantity of water or milk. Do not attempt to give liquids to an unconscious
person. Get immediate medical attention!
EYES: ................................................... Flush eyes with a large quantity of fresh
water for at least 15 minutes. If irritation persists, consult a physician.
SKIN (DERMAL): .................................. Flush from skin and clothing with large
amounts of fresh water. If irritation persists, consult physician. Wash
contaminated clothing before wearing.

SECTION VIII – EMPLOYEE PROTECTION

RESPIRATORY PROTECTION:............ Not usually needed in well-ventilated
areas. If needed, use a NIOSH approved respirator.
PROTECTIVE CLOTHING: ................... Nitrile or PVC gloves, and chemical
splash goggles. Wear protective outerwear and boots when product is likely to
splash.
ADDITIONAL MEASURES:................... Do not place this product in an
unmarked container! Keep away from children! Spilled material is slippery.


SECTION IX – SPILL AND DISPOSAL DATA

SPILL:................................................... Dike to prevent spillage into streams or
sewer systems. Consult local, state and federal authorities.
WASTE DISPOSAL: ............................. As recommended by local, state and
federal authorities.
HANDLING & STORAGE PRECAUTIONS: ................................ Store in a cool,
well ventilated area. Avoid overheating or freezing.


SECTION X – OTHER REGULATORY INFORMATION

PROPER SHIPPING NAME: Compounds, Liquid, Cleaning
NFPA HEALTH: 2
NFPA FLAMMABILITY: 0
HAZARD CLASS AND LABEL:NA
NFPA REACTIVITY: 0
ID NUMBER:NA 1760
NFPA OTHER: Alkali
PACKAGING GROUP:III

SECTION XI – PRECAUTIONARY STATEMENTS
WARNING:............................................ The information contained in this MSDS
is based on the data available to us from sources we believe to be reliable. No
warranty or guarantee expressed or implied is made regarding the accuracy of
this data or the results obtained from the reliance on this data. The manufacturer
assumes no responsibility for injury from the use of this product. Be safe-read
this product safety information and pass it on to all persons who may be exposed
to this product. Federal law requires it. This product and/or all of its components
are either included on or exempt from the TSCA Inventory of Chemical
Substances.

msds prepared by Lloyd Snell
for Annford Inc
1-800-866-7627 .....24 hour telephone